TenTec
[Top] [All Lists]

Re: [TenTec] Argonaut 509 Offset Tuning

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Argonaut 509 Offset Tuning
From: Mike Bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 4 Sep 2019 00:01:04 -0400
List-post: <mailto:tentec@contesting.com>
That’s normal

Mike Wb8vge 

Sent from my iPad

Knowledge is knowing a tomato is a fruit; Wisdom is not putting it in a fruit 
salad.
 

> On Sep 3, 2019, at 11:13 PM, Gary Follett <dukeshifi@comcast.net> wrote:
> 
> I am servicing a very nice Argonaut 509.
> 
> The RIT (Offset Tuning in Ten Tec-speak) works as it should when on.
> 
> However, when switched off, there is still a little RIT action, maybe 1 KHz 
> either side of center.
> 
> Is this normal for this radio? If not. I’ll go on the search…
> 
> It’s a simple circuit but I don’t want to waste my customer's money searching 
> for a phantom problem.
> 
> Gary
> 
> W0DVN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>