[Top] [All Lists]

[TenTec] MOLEX connector

To: TenTec@contesting.com
Subject: [TenTec] MOLEX connector
From: OZ6NF/Gunner via TenTec <tentec@contesting.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 23 Oct 2019 08:34:57 +0200
List-post: <mailto:tentec@contesting.com>
Thanks for many advices on how to change the MOLEX connector on my O2.
I chosed to follow the advice from Wes/N5WA. The holes for the connector in the 
PCB could accomodate my stranded AVG16 PTFE insulated wire, but not an AVG14 
wire. The holes could easily be sucked clean through the space for the MOLEX 
connector, so no need for dismantling anything apart from taking the lower lid 
Gunner / OZ6NF
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] MOLEX connector, OZ6NF/Gunner via TenTec <=