If receive is OK on 80M, best bet is a relay on the Low Pass Filter Board for
80M went south. Rather coincidental, I just pulled my spare stash of these
relays off the shelf to list them here for sale. Each of the LP filter sections
uses 2 relays. There really is not a great way to test which is bad without
removing them....then, once that work is done, it is recommended to just
replace both. A fellow can then test the 2 used ones, and keep the good used
one as a spare.
So,.... I have the relays, and will ship a PAIR, Brand New, for $25 via USPS to
lower 48 states. I am good on QRZ for email as well as mailing address.
Regards,
Greg, KC8HXO
On Monday, March 30, 2020, 02:33:26 PM EDT, Thomas Kuehl via TenTec
<tentec@contesting.com> wrote:
Jim,
And it puts out the correct power on the other bands?
Thomas - AC7A
On Monday, March 30, 2020, 11:25:01 AM MST, <1291jim@gmail.com> wrote:
Hello All,
I have a 6+ that was serviced by Ten Tec last year. Worked fine up until I
put it on the shelf for a few months. Just put it back on the bench and now
no transmit on 80M?
It is pulling amps like normal on 80 but nothing going out.
What do you think?
73, Jim
W6JIM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|