No question, do the A9 board recap.
I have fixed dozens of Orions with this simple fix.
Gary
W0DVN
> On June 7, 2020 at 9:17 PM Bernie Skoch via TenTec <tentec@contesting.com>
> wrote:
>
>
> Barry,
> I think your diagnosis is correct based on what you posted. It's consistent
> with the symptoms I experienced (and remedied with the A9 board fix).
> (I assume you have verified that the rig is connected to a good source of
> 13.8VDC.)
> Keep us posted.
> Bernie
>
>
> -----Original Message-----
> From: Barry Simpson <vk2bj@optusnet.com.au>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Sent: Sun, Jun 7, 2020 8:55 pm
> Subject: [TenTec] Start up issue with Orion 2
>
> Within the last few days, my O2 has had audio issues when first switched on.
>
> What happens is that a low level of continuous clicking occurs either from
> the headphones or loudspeaker, whichever is connected. The rig may then
> boot up normally after a few seconds or it might not.
>
> Switching it off and on again seems to overcome the problem.
>
> I am guessing that the issue might be the power board capacitor problem.
>
> I do have a full set of new capacitors ready to install but before I
> undertake the surgery, I wonder if anyone can either confirm my diagnosis
> or suggest that something else might be the cause.
>
> Thanks in advance and 73
>
> Barry Simpson VK2BJ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|