I feel like a page is missing in my Omni C manual? For filter board 48034.
This is the 2.4kHz filter that precedes the selectable crystal filter section.
Does anyone have that schematic?
I'm curious about modifying this board / swapping out / something. I use my
Omni C on CW and 2.4kHz is a bit too wide. I find I like 1.8kHz for "wide"
mode, and have a filter for that. 500Hz is nice to cut down on noise, and I
have that too. But both times I've operated in the ARRL 160m contest I've
found myself wishing for a 250Hz filter. So... maybe there is a way to slide
the filters around?
[Yes I know, I could just put 500Hz into the 1.8kHz slot, and 250 into the
500Hz slot, for when it's contest time. I will very likely do that as it's the
least amount of work! Probably "best" to leave alone and get a different radio
if I find this too limiting. Still, I'm curious.]
Thanks,Shawn KB1CKT
PS: I *did* notice that the Omni C has "low" sensitivity on 160! I suspect
what I should do is use a different RX antenna and just use a pre-amp on that
antenna, if needed.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|