><There is another reason to avoid aluminum. It's the reason electricians
>are not fond of it. That is, when aluminum is in a compression connection
>such as a screw terminal and it cools, the aluminum is squeezed. The
>squeezing causes it to spread sideways. When it warms up, it doesn't
>expand as much as it was squeezed because it's now wider. Sort of like
>expecting toothpaste to be resilient. The result is that the copper
>terminal expands more than the aluminum, so the joint becomes loose. If
>any appreciable current is flowing through the joint, it will then become
>hot. If hot enough, the aluminum will begin to oxidize. Aluminum oxide is
>a pretty good insulator. You get the picture. I'm using aluminum wire for
>my elevated radials, but I make sure that I periodically check the screws
>in the connections for tightness. There are also joint compounds available
>from electrical suppliers which will help. >
>
>
>Actually what happens is that electrolysis will occur when you join two
>dissimilar metals, e.g. copper and aluminum. The connection will begin to
>corrode when exposed to the weather and will become very high resistance if
>it even conducts current at all. This will happen despite the different
>coefficients of expansion between the copper and the aluminum. There is a
way
>to retard the electrolysis, though. If you use an antioxidant compound (such
>as Penetrox or Cramolin) you can slow the process down significantly. I
think
>this is the joint compounds you refered to Larry.
>
>73................de Goose W8AV
Goose, you're right about the electrolysis. Actually, both effects occur:
the unequal compression/expansion (whether indoors or out) coupled with low
resilience, and electrolysis. And yes, those are two of the compounds
mentioned. There are other brand names as well. They do help a lot. Some
of them are sold as aluminum/copper joint compounds, but they also work
well with aluminum/aluminum joints.
If you are using an aluminum plate and attaching aluminum wires, you can
still get electrolysis and/or compression problems, unless you are also
using aluminum screws, washers, and nuts. So it's a good idea to dope
everything with joint compound.
73
Larry, N9DX
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|