> Should I lower it to form more of and angle thereby increasing the
> capacitance?
If you form more of an angle you will lower the feed point impedance.
Has anyone had this type of problem?
> BTW I have about 45 radials ranging from 60 to 55'. The R measured at the
> base is right around 11 ohms which seems reasonable. My TS-850 tuner loads
> it fine but I think it should work better without the tuner.
> Any suggestions?
Use an UNUN or L network to match the low impedance.
>
> Tom W3TA
>
>
73, Tom, W1TO
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|