Ken, et. al,
If you are putting up a 160 meter tower or mast, why not just hang vertical
wires on the sides for 80 and/or 75 meters with plastic pipe or conduit for
a spreader and bring them to the same feed point above the ground radials?
No switching and it should cover both bands.
73 George K8GG
----- Original Message -----
From: "Ken" <k3yi@comcast.net>
To: "Topband" <topband@contesting.com>
Sent: Sunday, July 18, 2004 1:40 PM
Subject: Topband: Switch for 160 meter antenna
> Hello,
>
> I am building a 160 meter vertical antenna, and perhaps incorporate a 80
> meter antenna within the same structure.
>
> I would like to switch out a top section of the of the antenna by means of
a
> switch to break a connection leading to the rest of the above antenna
> circuit.
>
> I could easily do this with a relay, but I don't want to rely on any coil
> failures either due to voltages drop out or weakness of the coil of the
> relay.
>
> What I would like to fine if possible, a type of wiper or knife like
switch
> that can be activated by a servo or similar type mechanical devise.
>
> Does anyone know of such a switch, and where to fine it?
>
> Thank you,
> Ken
> K3YI
>
> _______________________________________________
> Topband mailing list
> Topband@contesting.com
> http://lists.contesting.com/mailman/listinfo/topband
>
>
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|