Perhaps liguid vinyl "tape" would be a superior overcoating compared to the
tape creep Mike mentions.
Garry, NI6T
-----Original Message-----
From: topband-bounces@contesting.com
[mailto:topband-bounces@contesting.com]On Behalf Of Michael Harris
Sent: Monday, September 06, 2004 6:49 AM
To: Larry Higgins; Topband
Subject: Re: Topband: TOP HAT GUY WIRES
G'day,
>
> > I forgot to mention that after using the conductive grease, I apply
> > sel-vulcanizing electrician's tape. This is the kind of tape where
the
> > rubber molds into itself and it becomes inseparable. It's similar to
>
> I've used that rubber tape for years with excellent results. However,
it
> will not withstand ultraviolet from sunlight. For that reason the
rubber
> tape should be applied first and then covered with vinyl tape.
A regular comment that, however, I've used it for years, clear atmosphere,
ozone hole, full exposure to sunlight, no over wrap, no problems.
Vinyl tape often starts to creep and peel off under hot/cold/wind
exposure, particularly if wrapped over an irregular surface.
Regards,
Mike VP8NO
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|