Greetings everyone
See my comments below ==>
.........................................................
Message: 4
Date: Tue, 28 Feb 2006 06:01:24 -0500
From: "Tom Rauch" <w8ji@contesting.com>
Subject: Re: Topband: high power filters
To: "Dick" <knaap159@zonnet.nl>, <topband@contesting.com>
> I want something that I can use behind a 160m MOSFET
amplifier, which
> haven't much filtering in the output.
> The amp has to be runned in a multi-multi station.......
BIG SNIP
The only good solution is to build a simple multiple section
low pass filter using transmitting components. Don't try to
use one of the narrow extra-deep notch resonant filters that
have second harmonic traps and the like. In the first place
you probably won't need it, in the second place voltages and
currents will be too high, and in the third place you might
not terminate the PA stage with the proper load impedance on
harmonics to prevent high voltages from damaging the FET's.
ANOTHER BIG SNIP
73 Tom
......................................................
Tom and others have provided many good suggestions.
You might also check some of the construction techniques
provided in a _Microwaves & RF_ magazine article titled
"Designing High-Power Series Inductors And Shunt Capacitors"
published October 1987 pp 97-98, 101, 103, 105 and 107.
Some of the ideas presented may be a bit large on 160-Meters
but definitely useful as one goes higher in frequency..
73 - Dick - w7wkr
I choose Polesoft Lockspam to fight spam, and you?
http://www.polesoft.com/refer.html
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|