<<It was my understanding that the coax braid should be connected to both the
radials and the base of the towers gnd system, but as you can see the the
minimum SWR and resonant freq. go crazy when I do.>>
A while back I posed an almost identical question to the group
regarding whether or not the tower and its ground rods should be
incorporated into (connected to) the radial system for the
vertical. My vertical is installed like an inverted L without the
top horizontal section. That is to say it is suspended vertically
alongside the tower and about 3.5 feet away from it.
<<My first mistake was connecting the radial ground to my tower
ground. Here's
what fixed the Inverted L:
1) Disconnected the tower ground from the radial ground and the SWR improved.>>
WOW! I received exactly the opposite advice to the same
question! SWR is not an issue with my installation, as I use a
remotely-controlled L-network at the antenna base and so can match it
either way. In fact, I have used it both ways (the difference in
tuner settings is small but significant), but haven't done any direct
A/B comparisons on air (would probably take too long to re-tune
between tries).
I was trying to find out which configuration caused the least amount
of interaction between tower and antenna, and consequently which way
resulted in less loss.
So, which way is best? And why?
73,
Charles - K5ZK
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|