John,
Yes, if both beverages are to be the same length, a single wire will work in
both directions. I take this approach on the E/W antenna: It's a single-wire
with transformers at each end and two runs of co-ax to the shack. For this
particular antenna, that was the cheapest / most-robust / easiest approach.
The antennas mentioned in my prior post used a shorter wire length in the
secondary direction, added as an afterthought subsequent to the installation of
the JA/EU antennas. It was an easy way to get two new directions for free -
spliced end-rolls were used for the wire.
Vy 73,
Jeff W0ODS
If you terminate both ends though, isn't it easier just to use one wire and
>relay switch between the feeder and termination R?
>73
>John
>
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|