Topband
[Top] [All Lists]

Re: Topband: RX epiphany?

To: "Bob Kupps" <n6bk@yahoo.com>
Subject: Re: Topband: RX epiphany?
From: "Tom W8JI" <w8ji@w8ji.com>
Reply-to: Tom W8JI <w8ji@w8ji.com>
Date: Fri, 14 Sep 2012 21:09:52 -0400
List-post: <topband@contesting.com">mailto:topband@contesting.com>
Hi thanks to all for the replies. Sorry I wasn't clear my QTH is northern Thailand. The point I was trying to make is that even though it is a noisy part of the season it is apparently less noisy at the European latitudes. Unfortunately I don't have enough land to put up a 160m Xmit 4 square and an RX array, it will have to be one or the other....


Bob,

A basic Inverted L or vertical would be maybe $100-500 US over here.

A 160 TX four square, if done right, costs thousands of dollars in the USA. It will generally receive only as well as a $25 Beverage antenna, maybe not that well, and you will have a one-band antenna. Unless you homebrew something, it will only have about five dB transmit gain at the most.

A linear amp that gives 13 dB gain is about the same price increase as a 5 dB gain four-square.

The linear works on all bands, has much more gain, and that frees hundreds of dollars for receiving antennas that can work on all bands.

To me it is a no-brainer for low bands. The normal reasonable order of progression is:

1.) good TX omni antenna

2.) good basic RX antennas that fit your location

3.) amplifier

4.) better RX antennas or bigger amp, depending on your results at this point

5.) after legal limit is reached and only if people have problems hearing you, only then comes transmitting antenna gain or 6 dB gain radials (as one person once claimed :-)

High transmitting antenna gain at the start makes sense on 20 meters and above, where antenna cost is low and the antenna can be a 1/2 wave or more high Yagi. My opinion is it makes no sense at all on lowest bands to start with TX antenna gain. The cost per dB is far too much.

73 Tom
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK

<Prev in Thread] Current Thread [Next in Thread>