Topband
[Top] [All Lists]

Re: Topband: Heathkit SB-1000

To: rlcariello@verizon.net, adkmurray@yahoo.com
Subject: Re: Topband: Heathkit SB-1000
From: Louis Parascondola via Topband <topband@contesting.com>
Reply-to: Louis Parascondola <gudguyham@aol.com>
Date: Thu, 17 Dec 2015 07:25:26 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>
SOmetimes many amps require additional padding on 160m  Add another 200pf to 
what is already there for 160.  It is necessary to put a brass washer around 
the contact on the wafer that adds in the padding cap on 160m.  See photo of 
Al-80A on internet to see where it needs to go.  This is a must or else 
eventually that contact will burn up if it hasen't already.



-----Original Message-----
From: Rich Cariello <rlcariello@verizon.net>
To: Jim Murray <adkmurray@yahoo.com>
Cc: topband <topband@contesting.com>
Sent: Thu, Dec 17, 2015 6:00 am
Subject: Re: Topband: Heathkit SB-1000

Jim,
To get closer to the needed value of the additional transmitting cap I would 
try to find out the max value of the load cap that came with the amp. Halve the 
value and that's what I would install. I recall the amp would kind of tune up 
around 2 mg with max load cap value. Adding an additional 50% cap allowed the 
amp to tune the hole 160 meter band. Bottom line just put in whatever you have 
and see what happens. But if you need to go out and buy something then the 50% 
cap value should do you. 
Rich AA2MF


Sent from my iPad

> On Dec 17, 2015, at 05:33, Rich Cariello <rlcariello@verizon.net> wrote:
> 
> Jim,
> If I remember correctly placing an additional transmitting type cap across 
> the units load cap did the job. Don't remember the value I used. My guess 100 
> or 200 PF. I used a cap I had in the junk box. You will need to remove the 
> cap in most cases for the other bands. 
> Rich AA2MF
> 
> Sent from my iPad
> 
>> On Dec 17, 2015, at 01:17, Jim Murray via Topband <topband@contesting.com> 
>> wrote:
>> 
>> Anybody know how to make an SB-1000 tune properly on 160?  Ok on other bands 
>> but doesn't like 160, dummy load or well tuned Inv.L.   Is it a quirk of the 
>> amp needing a modification or possibly a bad component?  Saw nothing obvious 
>> before putting it to use but have not had the cover off since.Thanks,Jimk2hn
>> _________________
>> Topband Reflector Archives - http://www.contesting.com/_topband
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband

_________________
Topband Reflector Archives - http://www.contesting.com/_topband

<Prev in Thread] Current Thread [Next in Thread>