Wellllll, found a #43 material core, wound the xfmr (just needed a 1.24 turns
ratio as my loop's Zo is 77 ohms, not the 5000 ohms that Rick, N6RK, had with
his loop) and installed it - used my Autek RF1 analyzer to check....49 ohms at
1.820 MHz and 1.2:1 VSWR...it's Miller Time ---- well, at least 'till I listen
around tonight and tomorrow morning to "see" what I hear...hihi
OHHHH - came inside the shack, turned the KX3 on to 1.820, connected the dummy
load....S0 noise, connected the loop, just a tad more "hearable noise" noise
than the dummy load but still S0, connected the Inverted U transmit antenna and
see S4 to S5 (a marked improvement over before when, without the matching
transformer, I observed S5 with the U and S3 with the loop...mucho better!)
Also, found all of the cores I would need at W8DIZ' store --
www.kitsandparts.com
Thank you all again for the assistance....71.5/72 de Jim R. K9JWV
________________________________________
From: James Rodenkirch
Sent: Saturday, April 2, 2016 6:48 AM
To: Top Band Contesting
Subject: Re: Topband: Receive loop observations
Thank you to all for the replies/comments/suggestions --- I am all over finding
a #61 or #43 material core for a xfmr....71.5/72 de Jim R. K9JWV
________________________________________
From: Topband <topband-bounces@contesting.com> on behalf of Jim Brown
<jim@audiosystemsgroup.com>
Sent: Friday, April 1, 2016 2:55 PM
To: topband@contesting.com
Subject: Re: Topband: Receive loop observations
On Fri,4/1/2016 1:36 PM, James Rodenkirch wrote:
> need to find a Fair-rite 61 core
N6RK notes that Fair-Rite #43 will work fine, with slightly increased
loss. Mu is higher, so you will likely need fewer turns to get 100 uH.
#43 is much easier to find.
73, Jim K9YC
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|