Topband
[Top] [All Lists]

Re: Topband: Waller Flag construction and performance

To: topband@contesting.com
Subject: Re: Topband: Waller Flag construction and performance
From: Bob K6UJ <k6uj@pacbell.net>
Date: Tue, 26 Apr 2016 19:10:29 -0700
List-post: <topband@contesting.com">mailto:topband@contesting.com>
Don't bash yourself too hard Ken. I have had my share of oops, what did I do ? :-)
It will be interesting to see what happens when you disconnect the feedline.


Bob
K6Uj

On 4/26/16 6:33 PM, Ken K6MR wrote:
Yes I did put that in. I think.  I modeled the whole thing and duplicated the phasing line lengths 
and crossover at the feedpoint. Although once I get it down I’m going to recheck that again. 
After my blunder with the resistors there’s no telling what else I’ve done wrong.

Thanks,

Ken K6MR



From: Lee STRAHAN<mailto:k7tjr@msn.com>
Sent: Tuesday, April 26, 2016 18:16
To: topband@contesting.com<mailto:topband@contesting.com>
Subject: Topband: Waller Flag construction and performance

   Ken, did you remember the 180 degree phase inversion needed on the Waller 
flag.
It will act like a very large signal level single loop if not.

Lee K7TJR

_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband

_________________
Topband Reflector Archives - http://www.contesting.com/_topband
<Prev in Thread] Current Thread [Next in Thread>