I have good luck with a pennant antenna, using a DX Engineering pre-amp at the
antenna. I live in a densely populated suburb, where it seems like every
neighbor has every RF noise-maker ever invented, and the antenna does a pretty
good job except for neighbors that are right off the front end of the antenna.
The down-side is that it's fixed direction; but I have seen info about someone
who built one on a rotating platform. There's a ton of information about how
to make them at http://www.angelfire.com/md/k3ky/page37.html
<http://www.angelfire.com/md/k3ky/page37.html>
Art Delibert, KB3FJO
North Bethesda, MD
________________________________
From: Topband <topband-bounces@contesting.com> on behalf of K1FZ-Bruce
<k1fz@myfairpoint.net>
Sent: Thursday, September 22, 2016 11:47 AM
To: Topband
Subject: Topband: 160 meter starter antennas
This is the time of year that many of us in the Northern Hemisphere have been
waiting for.
DX is coming up, long and stronger. Many 'old timers' have their antennas
"ready to roll".
New comers to the band may want an inexpensive starter receive antenna, If
there is space
a beverage is a good forgiving antenna.
For limited space:
Despite some criticizing, a loop antenna can result in many DX contacts. Even
SWL's in the AM radio BCB like them.
Yes there are always better antennas, but many of us started with in-expensive
wire types.
73
Bruce-k1fz
http://www.qsl.net/k1fz/flag_antennas.html
flag_loop_antennas - QSL.net<http://www.qsl.net/k1fz/flag_antennas.html>
www.qsl.net
Recommend a 900 ohm low capacitance primary antenna connection. Isolation: Less
than 6pf (3-4pf typical) inter-winding capacitance for minimum common mode
transfer ...
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|