I think the best method is F connector, snap and seal, if you must have
a 259 use an adapter.
Renée, K6FSB
On 2016-12-04 11:50 AM, Larry via Topband wrote:
hi guys,
planning on installing some more beverages. i have a roll of CATV 75 ohm cable.
it is the kind with a double shield. aluminum wrap over tinned copper shield.
there is some kind of sticky on the shield and i dont think that i can solder
efficiently to it.
what is the best way to clean the "sticky" off the shield so that i can solder
to it for PL259's?
thanks,
larry
n7dd
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|