Your QTH is not showing up a part of the sent exchange.
Change N7WS 599 to N7WS 599 xxx where xxx is the QTH you sent.
Tree
On Tue, Dec 6, 2016 at 3:00 PM, Wes Stewart <wes_n7ws@triconet.org> wrote:
> I operated some S&P during the ARRL contest. I'm not a contest op but
> wanted to give the guys I worked some points, so I tried submitting a check
> log.
>
> I use DXBase for my logging program so I created an .adif file of the QSOs
> and used ADIF2CABR V.3.10 (C) SP7DQR to make a Cabrillo file.
>
> When I submitted I saw in part this:
>
> *ERROR-->*Following QSO errors were found:
>
> * Sent exchange is missing sec for each QSO
>
> *WARNING-->*Following QSOs were missing required exchange info. You may
> want to correct these when you resubmit your log.
>
> * QSO: 1814 CW 2016-12-03 0611 N7WS 599 AA5B 599 NM
> copied exchange (sec) is missing
> * QSO: 1805 CW 2016-12-03 0231 N7WS 599 AC0W 599 MN
> copied exchange (sec) is missing
> * QSO: 1815 CW 2016-12-04 1454 N7WS 599 AC7A 599 AZ
> copied exchange (sec) is missing
> * QSO: 1808 CW 2016-12-04 1307 N7WS 599 AI7H 599 ID
>
> and so on and so forth.
>
> So what's the problem?
>
> Wes N7WS
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|