I'm going to replace all F connectors on my Gel coated CommScope Flooded
RG6 coax. This is on my YCCC RX 9 Circle . and is a intermittent
problem , I have a few questions in hope to do them correctly this time .
I see the big box store sell a double O Ring Connector . Do these look
like a reliable connector ?
https://www.homedepot.com/p/Klein-Tools-F-Compression-Connector-RG6-for-Above-Ground-Outdoor-Use-50-Pack-VDV812-624/203579038?cm_mmc=Shopping%7CG%7CBase%7CD27E%7C27-9_HOME_ELECTRONICS%7CNA%7CPLA%7c71700000034238993%7c58700003946879311%7c92700032387804670&gclid=CjwKCAjwvNXeBRAjEiwAjqYhFoLv1z0hE5ah55DV3VCxOj7V0erdcuOH4UxmC1zfmr9PJ6VILbK01hoCo7cQAvD_BwE&gclsrc=aw.ds
I have the 1/4 1/4 coax stripper and a good Klein crimper and have
watched YouTube showing how to fit the connector to the Coax . Look to
me like their simply pushing them to the right depth and crimping. Is
the more to it then that ?
After stripping with the 1/4 1/4 stripper , Should I remove the sticky
Gel from the braid of the flooded RG6 before applying the connector ?
If so what do you use to remove the Gel ? I didn't do this last time ,
my be my problem ?
All RG6 is under ground in 3/4" PVC with weather heads , the coax could
be replaced if needed. I tested for open or shorts all tested good with VOM
Thanks Ed N5DG
---
This email has been checked for viruses by AVG.
https://www.avg.com
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|