Topband
[Top] [All Lists]

Topband: ARRL 160m

To: Topband <topband@contesting.com>
Subject: Topband: ARRL 160m
From: VE6WZ_Steve <ve6wz@shaw.ca>
Date: Mon, 9 Dec 2019 09:35:49 -0700
List-post: <mailto:topband@contesting.com>
This was the first time I made a serious attempt at the ARRL 160m contest. 
Usually I will just poke around and hand out mults.  Since condx were looking 
pretty good, I decided to stay in the chair a bit longer.

I must say I forgot how this contest is really more like SS with some DX thrown 
in rather than a real DX contest. I knew the band was in great shape to EU 
because of how loud the EU callers were, at least 4 of which were dupes. At 
around 4 AM, John SM5EDX called in to tell me I had a great signal at his local 
NOON! So I knew the band was in good shape over the pole at my morning. The 
band was wall-to-wall during prime-time, but I could usually find a CQ hole 
somewhere.  If you left a run spot to go pee, it would be gone within about 1 
or 2 minutes.

1319 QSOs (1381 total QSOs but 62 dupes!!! some guys just kept duping me, 
multiple times…I just kept logging them)
83 sec (I worked all sections  before I went to bed Friday night)

52 DXCC:

EU- 114 QSOs, 25 DXCC

AS- 97 QSOs, 5 DXCC: 86 JA, 7 UA9, 2 HL, 1 BY, 1 JT

OC- 8 QSOs, 2 DXCC: 7 KH6, 1 5W

SA- 3 QSOs, 3 DXCC: 1 CE, 1 YV, 1 PJ2

AF-1 QSO, 1 DXCC: 1 D4

I was operating my remote station using the Flex 6600, ACOM 2000a, 2 el TX, and 
multiple RX.
My preferred radio is the K3s because it has superior weak signal RX, but it 
has no waterfall via the remote.

My remote station is a challenge to operate a contest like this. Here is some 
info on how things are set-up.

I am not "a boy and his radio",  I am "a boy and his PC".  I use the Flex 6600 
PC software on one monitor, and the remote station PC is on the other monitor 
where I log with N1MM and control the station.  There is no physical radio or 
switching at the operating table. Just the PC, a mouse and a keyboard.
I always use diversity RX with my 9 circle array in one ear, and the Beverages 
in the other. Each has 8 compass directions and each are controlled with a 
clickable rotor compass dial on the PC.  SO...to change directions I need to 
click the 9 circle, then click the Beverage selector, and then click the TX 
array direction, then get the cursor back to N1MM to log. Often I would be RX 
in multiple directions in each ear which was handy, but boy....Im pretty sure 
I'm developing carpel tunnel syndrome from using that mouse!  During the 
morning run was really crazy...JA, OC, NA, N polar and EU all possible signal 
arrivals!
If I was RX for JA, and some polar EU would call if I had one ear on EU I might 
hear them, but then if they are weak, I need time to switch the other RX to 
have good copy.  If the callers are only dumping their call once…I might not 
get it.  Same with NA calling from the back of the RX.  The Beverage broadside 
phased pairs are very sharp, and the difference can be copy-no copy just 
between N to NE.  I may consider adding my RBN skimmer 30m loop into the RX mix 
so I can have “omni” rx, but it does not hear as well.
So if I missed any callers, or seemed really slow responding, it was probably 
because I was busy switching my RX and struggling to get the mouse back into 
N1MM to type in a call.  This is one disadvantage of the remote compared to 
having a physical direction switch so I could keep the focus on N1MM.
There were some very exceptional EU signals, some of which when they called I 
was sure they were NA.
On Friday night at 0730z JE1BMJ and JE1CKA got my attention even though I was 
RX for EU. This was just at JA sunset. I switched to JA and had a nice run on 
41 JA till I went to bed at 0830z.
Congrats to Joel VE6WQ at VE6JY and Eric VE6BBP who were both rocking the band 
during the contest.

Thanks to those how called me and could hear me.
Lets hope these great conditions persist throughout the season.

73, de steve ve6wz
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
<Prev in Thread] Current Thread [Next in Thread>