I'm planning to mount a TR-44 rotor on top of three (9-ft) sections of push
up South River mast, the lowest section will be attached to the house above
the garage and the upper two sections, 3-point guyed to the roof.
QUESTION-#1: Would it be recommended to mount a vertically polarized
11-element 2-meter beam about 3 or 4-ft above the rotor AND the R-5 vertical
above the beam on the same upper mast pipe?
QUESTION-#2: If this is a feasable [safe] mounting set-up, what would the
recommended spacing be between the bottom of the R-5 and the upper ends of
the beam elements- for minimal interaction?
QUESTION-#3: Are there any special precautions or recommendations I should
take with this mounting arrangement?
I can't begin to tell you all how valuable this reflector has been to me
these last few weeks that I've been a member. I've learned stuff I would
never had read anywhere else. Keep up the good work and the knowledge flowin'.
Roger, K2JAS Publications,.... Publishers of the most comprehensive and
accurate repeater directories and laminated repeater maps for the 2m/70cm
bands in the states surrounding New Jersey!
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com
Sponsored by Akorn Access, Inc & KM9P