Victor A. Dubois wrote:
> I bow to the antenna specialists on this reflector and pose the following
> I know the resonant frequency will change on the antenna when installed on
> top of a tower versus being at 6 feet or so. The question, how much acn I
> expect the resonant frequency of a 6 element 15 meter monobander to change
> when installed on a 120 foot tower versus at 6 feet? There are no other
> antennas on the tower to interactr with the beam.
> Thanks in advance.
> Vic N4TO
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: email@example.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: K7LXC@contesting.com
> Sponsored by Akorn Access, Inc & KM9P
There are many ways to determine this:
1. Model it on your PC using a variety of programs sold in QST.
2. If you have the antenna built, raise it with a non-conducting rope,
pointing it straight up, with the reflector about 4 feet (or more) off
the ground and measure it with a handheld analyzer (AEA or MFJ are two
that seem to work adequately for this purpose). A QST article in the
past year or so showed that this method is very, very accurate.
3. My experience is that some antennas move up in freq 5%, others move
up 10% or more in freq as they are raised from a few feet off the ground
to their resting height a significant fraction of a wavelength in the
air, depending on antenna design.
I'd suggest (1) or (2) depending on whether it's vaporwear or hardware!
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com
Sponsored by Akorn Access, Inc & KM9P