Michael Tope wrote:
> I am interested in a good method for grounding a piece of 1/2" CATV hardline
> as it passes the base of my tower. I would like to get a good solid
> connection, but am concerned that anything that clamps to the hardline
> asymmetrically will deform or crush the relatively soft aluminum outer
> conductor. The cable is jacketed, so the fixture in question would
> necessarily have to open wide enough to accomodate the extra diameter of the
> jacket if it were to be slipped over the end. Alternatively, I was thinking
> that with something like a pair of clamp shells, they could be placed at the
> ground point directly without having to feed thru the 30 remaining feet of
> Anybody solved this problem already? I am hoping the there is some little
> gizmo waiting for me at the local hardware store that will do the job
> directly without the need for alot of modification.
> 73 de Mike, AD4VH...................
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: email@example.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: K7LXC@contesting.com
> Sponsored by Akorn Access, Inc & KM9P
I would use homemade clamps. I start with a piece of 3/4 inch aluminum plate
2 inches square. I drill the appropiate size hole through the plate for the
jacket. Then I flip the piece 90 degrees and drill two 11/32 holes on each side
the center hole and perpendicular to it through the edge of the plate for the
inch clamp/mounting bolts. Then I saw the whole thing in half and the saw cut
about the right crunch. Depending on where it is going, I may make the
spacing fit a U bolt and then grind/file radious to fit tower leg. When
clamping to a
tower leg, I would use a stainless steel bolt, and a thin piece of stainless
the aluminum block and the galvanized tower leg with lots of anti-ox compound.
seal the clamp, leg and cable like it was a coax joint to keep the water out.
No moisture means no electrolysis.
It is cheap and takes me about 15 minutes to make with a drill press, band saw
de n0yvy steve
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com
Sponsored by Akorn Access, Inc & KM9P