I had several requests to pass along the any info I received on my TB3
question. Here's a good tip from W0UN:
>Date: Fri, 10 Jan 1997 21:02:51 -0600
>To: AA1K Jon Zaimes <email@example.com>
>From: John Brosnahan <firstname.lastname@example.org>
>Subject: Re: TB3 Thrust Bearing
>>I recently acquired a TB3 thrust bearing that had been in service for
>>several years. When I removed it from the tower it was not turning smoothly;
>>seemed like there was either serious dirt in there or perhaps busted bearings.
>>I'll try a simple cleaning first, of course, but if there is internal damage
>>I was wondering if these can be rebuilt?
>Jon, don't have one in front of me to remind me exactly how
>to take it apart (it has been a few years)--but there is an allen set
>screw in the side that will allow the bearing to be removed once it is
>unscrewed. Then you can pull it apart--check the bearings, check the
>lube, and check to see if the bearing race is still in good shape.
>When time to reasseble--just put the halves back together push
>the ball bearings back in and put the set screw back.
>No, it isn't obvious at first glance--but once you know the trick it
>will be very satisfying!
>]gl es 73 John W0UN
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com
Sponsored by Akorn Access, Inc & KM9P