>Date: Sun, 23 Mar 1997 05:14:48
>To: "Roger L. Elowitz" <K2JAS@worldnet.att.net>
>From: AA1K jon zaimes <firstname.lastname@example.org>
>Subject: Re: Rotator Cable Alternatives
>At 09:43 PM 3/22/97 -0500, you wrote:
>>The best idea I've heard about lately... other than the expensive in-line
>>waterproof connector the rotor guys sell (assuming a HAM # style rotor) is
>>to ... a) remove the screws from the rotor terminal strip, b) remove the
>>two screws holding the terminal strip on the casting, c) thread your control
>>wires through the terminal screw holes of the terminal strip and solder them
>>to the connections inside, d) re-attach the terminal strip.
>Hi Roger...Still the best idea on this I've heard of too! I did this on one
of my T2X's a few years ago when the terminal strip threads stripped out.
Even with a good terminal strip on the rotor, using the 3-foot pigtail is a
good idea to avoid having to deal with making the awkward connections to the
rotor strip when the rotor is mounted on the tower.
>At the end of the 3-foot pigtail I used two variations, at different times.
One was to twist the wires together and tape the connections with cheap
black electrical tape. The other was to use a large terminal strip and make
the connections with it. Then I taped up the whole strip. Both methods were
in use for several years without problems.
>Just twisting the wires has the advantage of limiting the connection to
identical or similar metals. Using a terminal strip or wire nuts with a
dissimilar metal might accelerate corrosion of the connections.
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA