I just received my new T2X rotor from Norm's and have bench tested it and
everything works just fine. I will be installing this within the next week
in my Rohn HDBX48 with top thrust bearing. I will be rotating my KLM KT-34XA
Tri-Bander and a small 2M beam. I am installing new 8-wire rotor cable at
the same time. The cable run is only about 80ft.
My question is: Is there anything else that I should do before installing
this new rotor?
Thanks, in advance.
Chuck Sudds K0TVD
Missouri Valley, IA USA
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com