Towertalk
[Top] [All Lists]

## [TowerTalk] Finding roof beams, determining impedance of coax cable.

 To: [TowerTalk] Finding roof beams, determining impedance of coax cable. "k4sb@worldnet.att.net"@worldnet.att.net (Edward W. Sleight) Fri, 27 Jun 1997 01:05:37 -0700
 ```Enjoyed your discussion of the "stud" finders Jim. Use the electronic type also. But, your bit on determining the impedence of an unknown cable is a wee tad off. ASSUMMING that you meant a half wave ELECTRICALLY, the line will repeat its input impedence ( and with a non inductive resistor, X will be 0 so you can just as well say input resistance, at the other end of the line without regard to the impedence of the actual cable itself. With a random length of line ( such as anything from a few feet to a half wave physically, the result on the SWR ( or other meter used ) will be useless because of the characteristics of the SWR bridge. The only way I have ever known( assumming it isn't marked on the cable ) is to use the ratio of the diameter of the inner conductor to that of the outer diameter, and compensate by applying the approriate factor of the the dialectric material. You can determine this by working the formula backward using known factors, ie: if you have a piece of marked 50 ohm coax with a foam dialectric, work the formula by just using the diameters of the inner and outer, and then compensate by dividing 50 ohms by the figure you get. Best Ed -- FAQ on WWW: http://www.contesting.com/towertalkfaq.html Submissions: towertalk@contesting.com Administrative requests: towertalk-REQUEST@contesting.com Problems: owner-towertalk@contesting.com Search: http://www.contesting.com/km9p/search.htm ```
 Current Thread [TowerTalk] Finding roof beams, determining impedance of coax cable., Flanders, Jim [TowerTalk] Finding roof beams, determining impedance ofcoax cable., David O Hachadorian [TowerTalk] Finding roof beams, determining impedance ofcoax cable., k4sb@worldnet.att.net [TowerTalk] Finding roof beams, determining impedance of coax cable., k4sb@worldnet.att.net <=