Bob Bergman wrote:
> I am just in the planning stages for next summers antenna project and
> have a BUNCH of questions:
> First of all, I currently own a Force 12 C4XL/d that is mounted 4 ft
> above the top of a Rohn SSV tower. The SSV houses 2 - thrust bearings,
> one at the top and one 6 ft below the top. A Tailtwister is mounted 9 ft
> below the top of the tower, turning a 2.0 inch OD carbon steel mast.
> I have located a chromemoly (sp?) vendor in Denver that has 2.0 OD, .25
> inch wall, spec 4130 chrome molly tubing for $7.12 per foot ( not
> galvanized ). Maximum 24 ft.
> Northern Colorado, 90MPH zone.
> THE PLAN:
> Replacing my carbon steel mast with the CM.
> Fabricating an extension of carbon steel mast between the rotor and
> first thrust bearing from the existing mast and a 24 inch piece of 2
> inch ID sleeve material (.18 inch wall.) Set the CM mast in the
> extension so as to allow the CM mast to pass through both thrust
> bearings. This will put the top of the CM mast approx 17 ft above the
> top thrust bearing (top of tower.)
> Install the Force 12 C4XL/d, (wind load 9.6, weight 65#, boom length
> 30 ft, mast torque 900 in/lb) at the top of the mast. Allowing height
> for the truss cable, this should place it about 14 ft above the tower.
> Install a new Force 12 Magnum 520, (wind load 8.1, weight 57#, boom
> length 36 ft, mast torque 700 in/lb) 10 ft below the C4XL.
> Whatever CM spec 4130 is, will it be strong enough to handle this
> load with .25 inch wall or should I go stronger? .5 inch?
> Would it be better to place the 520 on the top, over the C4XL?
> Is there a different design that I should consider?
> Would I be pushing the limits of the Tailtwister?
> What is the optimum spacing (givin what I have to work with) for
> these two yagis? With a lesser distance between yagis, the manufactured
> mast extention at the rotor may not be necessary (top of mast 15 ft
> above tower.)
> Any suggestions and/or comments are welcome! This is what planning is
> all about!!
> Tnx & 73's
> K0FR -- Bob
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: firstname.lastname@example.org
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: email@example.com
> Search: http://www.contesting.com/km9p/search
Doesnt the C4xl already have 20 meters? If so, you are going to have
serious problems with those beams being so close together and resonant
to each other.
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com