Chuck Dietz wrote:
> I thought I had my 2 tower erection project all ready when I noticed
> some 1/4" thimbles in one of my Rohn 45 torque assemblys. The hole
> looked small so I tried a 3/8" thimble in it and sure enough, it was too
> small to accept the 3/8" thimble. Therefore I cannot use the 1.4"
> preformed guy grips because the radius of a 1/4" thimble is too small.
> Now I know that in the "old days" we never cared about the radius a guy
> wire or a guy grip was going around, but I am trying to do it right this
> Do I just "surrender" and use 1/4" clips with the 1/4" thimbles at the
> torque bars? (This is my soloution) or does anyone have a better
> soloution where I can use grips at the torque arms?
> Chuck, KZ5MM (ex: KE5FI)
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: email@example.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: firstname.lastname@example.org
> Search: http://www.contesting.com/km9p/search
Yes, you have to use a shackle in between the arm and the thimble.
The pin of the shackle goes through the arm hole, with the shackle and
thimble linked together.
BTW, in case you are wondering, for 1/4" EHS, you need 3/8" heavy duty
thimbles. (The thimble is always 1/8" larger than the cable size)
73, Ty K3MM
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com