At 10:35 AM 11/7/97 -0500, you wrote:
>In a message dated 97-11-07 09:53:11 EST, email@example.com writes:
>> Works better if you silver solder
>> the connections, but I have also gotten away with clamps.
> Silver soldering or brazing a transmitting antenna ground system is
>mostly okay as are good mechanical compression connections. Use of an
>antioxidant is highly recommended.
> For a lightning protection system, DO NOT solder anything. One direct or
>even indirect hit will heat everything up enough to melt the solder - no more
>ground system. See my previous post about compression or exothermic bonding.
> A reprint of my article on 'grounding systems for hams' is available for
>an SASE. Send to TOWER TECH, Box 572, Woodinville, WA, 98072.
>73, Steve K7LXC
Good point Steve. When I do this, I usually clamp everything together and
then silver solder. I have used various types of clamping devices....from
saddle clamps...to large electrical clamps. I then silver solder
everything...including the clamp and all. If you want to remove it...you
got to cut it out. I haven't taken the time to silver solder connections
recently because my station is in a state of flux all the time, so I clamp.
I usually use two.
I've seen "professional" tower installers do this same thing and braze it
all together. Although, they did some other stuff which I questions. Do
not rely on hose clamps.
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com