Don't use TEK screws-they rust easily and are disimilar metals-they will
cause the joint to seize. I use TEK screws extensively in my business doing
mobile installs, and I see what happens to grounds etc that people put in
wet environments with these. Use stainless steel screws, and predrill the
TEK screws have a time and a place, and it's not on antennas.
Maybe others have a different feeling on this, and flame away if you must,
but i've used these for 18 years, and have seen what happens to them
asbestos undies now on
At 11:28 AM 11/15/97 -0500, you wrote:
>In a message dated 97-11-15 10:47:19 EST, firstname.lastname@example.org writes:
>> Before any antenna
>> goes up in the air, we drill out every joint and rivet them, a la Force
>> This is in addition to all the hose clamps, compression straps (and the
>> have many), etc. Why go through "all that trouble?"
>> My feeling is that it is MUCH more work to first pull the antennas down
>> after they are up. The rivets provide two distinct benefits. Firstly, they
>> strengthen all the joints (I have never had a KLM "vibrate apart," not
>> my 4L 40, as so many folks are wont to claim), and secondly, when I must
>> take one apart for some reason, I NEVER have to worry about replicating
>> exact dimensions again. The rivet holes do that for me.
>> The small amount of additional preparation while on the ground saves us
>> many, many more times the work if it doesn't hold up while on the tower.
> Here's another way to do it. Since the rivets take a 2-step process
>(drilling the hole and then installing the rivet) and takes a special tool
>(the pop riveter), here's a one-step way to do it that I have used for years
>- I use Tek screws to do the same job. They are chisel-point self-tapping
>screws that you can get at most hardware stores. All you need are short ones
>with a Phillips head on them and an electric drill with a Phillips drive.
>They provide a nifty mechanical AND electrical bond.
> I'm ignoring all discussions of how a hole weakens the aluminum element
>by introducing a stress riser. If you put them on the BOTTOM of the element,
>you minimize the potential problems of drilling a hole in the element.
>73, Steve K7LXC
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Administrative requests: towertalk-REQUEST@contesting.com
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com