My good SWR/Power meter (Nye RF Power Monitor) is attached to the output of the
amp, so I don't see any SWR affects from the amp. I can also measure SWR/Power
with the built-in unit in the TS950SDX. The amp affects SWR a bit, but not so
much that it would bother me.
73, Dick, WC1M
From: Pete.Smith. <email@example.com>
To: Pete.Raymond. <firstname.lastname@example.org>; Bill.Fisher.-.W4AN.
Cc: email@example.com <firstname.lastname@example.org>
Date: Saturday, December 20, 1997 1:30 PM
Subject: Re: [TowerTalk] Radials, resonance and the MFJ259
>At 09:02 AM 12/20/97 -0500, Pete Raymond wrote:
>>>I have an AEA SWR121 and it tracks with my Bird wattmeter. One thing that
>>I have found is that
>>my Alpha bumps up the vswr a little. When the linear is in bypass the xcvr
>>shows a different vswr
>>reading than if I remove the coax from my switch and measure with the AEA
>>unit. Again the reason
>>being is that the linear bumps up the vswr a little. Not sure if this is
>>your condition but one to
>>consider. 73 Pete N4KW, Inverness, Fl.
>In my case, the amp makes a huge difference. Just measuring with my
>transceiver, if I measure through the amp my lowest SWR on 20 falls well
>above the band - 14450 or thereabouts - while measuring without the amp, it
>falls at about 14200. My Autek tracks very well with the transceiver in
>this respect. Quantitatively, the minimum SWR readings are similar, both
>with the amp and without. Clearly, these are transmission line
>"transformer" effects, intended or not. If your feedline isn't perfectly
>matched and a multiple of a half wave at the operating frequency, the only
>way to see real resonant frequency is to measure at the antenna. At the
>antenna, the resonant frequency is 14175.
>73, Pete Smith N4ZR
>"That's WEST Virginia. Thanks and 73"
>FAQ on WWW: http://www.contesting.com/towertalkfaq.html
>Administrative requests: towertalk-REQUEST@contesting.com
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com