Towertalk
[Top] [All Lists]

[TowerTalk] How bend aluminum tubing

To: <towertalk@contesting.com>
Subject: [TowerTalk] How bend aluminum tubing
From: kn6di@groupone.net (Dan Arney)
Date: Fri, 14 Aug 1998 18:23:12 -0700
Try an electrician with an EMT tube bending set. If is hard T1- T6 etc yoou may
be out of luck unless you soften it at the bend radius, after bending the heat
and anneal it.
Hank KN6DI


Steve Lawrence wrote:

> I need to put a 90 degree bend in 1/2 inch 1/16 wall antenna element
> aluminum tubing. Suggestions for applying a reasonably smooth radius
> without cracking or excessively fatiguing the aluminum will be appreciated.
>
> Tks & 73, Steve WB6RSE
>
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm




--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>