im getting ready to raise a hygain 205 ca next weekend. it is on the tram
cable and ready to go up. it is set to factory measurements for low cw. i
tried sliding it up the tram to about 30 feet or so for a test. i show an
1.8 for the low swr at 13.8 mhz. i guess this is because of the ground
being only 30 feet below the beam. anybody out there just set to stock
measurements and go up with it and get good readings?
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com