Baseboard heaters usually have no neutral and the
ground that is there is not of sufficient size to
handle being a neutral too so converting to 2 110V
lines is out of the question. However, most baseboard
heaters are wired with 12/2 + ground, so changing it
from 220V to 110V/20A would be as easy as changing the
breaker and outlet. If it is 12/2 (and most baseboard
heaters I have seen are) then you can run 20 amp
appliance outlets instead of the standard 15 amp.
---Steve Zettel <email@example.com> wrote:
> A question a little different than the normal queries about having a
220VAC circuit in the shack for an amp:
> I already have 220VAC available at the baseboard in almost every
room of the house, after removing the old baseboard electric heaters.
In a couple of rooms, it would be nice to have more 110VAC circuits,
including the shack -- computers and perirherals, audio/video home
theater setup, sewing and crafts all use more than the normal
allotment of 110VAC outlets. At this point, I am re-paneling and
re-sheetrocking some of the rooms, and it would be a convenient time
to install additional boxes and outlets.
> Although it looks feasible on the face of it to turn one 220VAC
circuit into two 110VAC circuits, I have the feeling I am missing some
very basic, obvious caveats.
> Advice (other than the licensed electrican, get the permits, etc)?
> Steve Zettel KJ7CH
> near Libby, MT USA
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: firstname.lastname@example.org
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: email@example.com
> Search: http://www.contesting.com/km9p/search.htm
**************** Give Every Man His Dew! ******************
Michael A. McCarthy, President
Everest Engineering Corporation
4 Barnes Circle
Marlborough, MA 01752
Voice: (508) 460-6737
Fax: (508) 460-7951
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com