On Mon, 29 Mar 1999 18:36:15 -0800 Steve Gehring / KL7DC
> I grabbed an "odd" piece of coax (128 inches of
>RG-11) from the shack closet and connected it to my Autek RF-1. For
>open stub test, the impedance bottomed out at 15.05 MHz with 7 ohms,
>only rose to 13 ohms at 14.05 MHz, or 1 MHz lower.....
> Now, my Autek worked fine for this
>and made finding the center of that low Q, broad notch and/or
>rather uneventful. I've never used an MFJ, but would guess the SWR
>peak during the stub's electrical shorts and opens. I feel they are a
>way to check your work, especially with possibility of length
>miscalculations and varying velocity factors, etc.
I didn't see the original posting on this, but something is wrong
here. A 10' stub made out of rg-8 or rg-11 should have an impedance
minimum of about 0.5 ohm. I just tested my 40m shorted stub, made out
of rg-8, and it read 0 ohms from 14.0 to 14.7 Mhz on the Autek
meter. This is a false reading, though, because of the "diode
suck-out" problem discussed in the Autek manual for very low impedance
I still think the best way to tune a stub is to
beg, borrow, steal or buy a grid dip meter, temporarily connect a
1 inch piece of wire from the pin to shell of the stub's pl-259,
and couple the gdo into the small square loop formed by the little
wire, the pin, and the shell of the pl-259.
Dave Hachadorian, K6LL
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com