Try using a good sized drill, ball bearing, sleeve and a two small hydraulic
jacks. The idea is feasible and one I used to turn a beam. It takes a little
engineering, but as the oil raises the jack at the top, the drill spins the
fixed ball bearing quite well, and will spin quite a bit of weight.
One of the expensive parts is the tubing to get up the tower from the shack. It
would take quite a bit of explanation here on the TT Site. I would like to
collaborate with any who wish to use the hydraulic rotor.
73 de n8csp k
"Scott E. Olitsky" wrote:
> I am putting up a large dish with a 4 inch mast. Does anyone have any
> suggestions as to how I might be able to turn this other than using a rotor?
> The dish will "sit" on top of a 4 " pole. The dish mount has a "cap" on it
> that will actually sit on top of the pole. What would be a good way to
> connect the mount to the pole so that it could rotate accurately and
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: email@example.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: firstname.lastname@example.org
> Search: http://www.contesting.com/km9p/search.htm
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com