Towertalk
[Top] [All Lists]

[TowerTalk] Soldering PL-259s

To: <towertalk@contesting.com>
Subject: [TowerTalk] Soldering PL-259s
From: dwindk3bhj@fuse.net (David J. Windisch)
Date: Thu, 9 Dec 1999 08:57:16 -0500
Remove the tip, attach a couple of carbon rods, and use it as a resistance
heater ;-)>
keBHJ
Dave,
----- Original Message -----
From: Pete Smith <n4zr@contesting.com>
To: <towertalk@contesting.com>
Sent: Thursday, December 09, 1999 07:19
Subject: [TowerTalk] Soldering PL-259s


>
> This is probably nothing new for the old-timers, but if you're using a
> Weller-type soldering gun on PL-259s and the heat output seems marginal,
> take pliers and tighten up the nuts that attach the tip, as hard as you
> can.  Even 1/16 turn can make a dramatic difference in the amount of heat
> generated.
>
> BTW, the "easy to solder" PL-259s from the Wireman also help, as does
using
> his RG-8X low-loss, which has a tinned shield and foil inside that.  I'm
> replacing all my jumpers in the shack, in the hope of cutting down on
stray
> RF.
>
> No connection with Press, just a happy customer.
>
> 73, Pete Smith N4ZR
> n4zr@contesting.com
>
> Sometimes a tower is just a tower
>
> --
> FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
> Submissions:              towertalk@contesting.com
> Administrative requests:  towertalk-REQUEST@contesting.com
> Problems:                 owner-towertalk@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm
>


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>