I'm in need of the bolt patterns for the G800S & Tailtwister rotators. I'm
fabricating rotator shelves for these rotators for someone else & I would
like to know where to bore the holes, relative to each other, on the plate.
I know the Ham II/IV series is on 3" centers, is the Tailtwister the same?
I do not have either of these rotators. Any useful information is very much
Robin E. Midgett KB4IDC EM66se
1/2 of the Award Winning NT4L Rover Team
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Administrative requests: towertalk-REQUEST@contesting.com