Most of my guy wires use clamps but that is because I put
them up before I knew about grips. If I were doing it over,
I would use grips. The power companies and telephone
companies use mostly grips and, for the most part, I believe
they know what they are doing.
There is yet another method: Nicopress fittings. They are
usually made of copper (but there are some made of other
metals) and crimped in place with a special tool (expensive
. . .). I have seen a lot of these used on large cranes and
I think crane riggers know what they are doing, too, for the
Tom Mattus wrote:
> Hello Gents,
> I'm planning my tower systems, (two), and would like
> to learn the best method for cable terminations and
> why. Clamps or grips? The cost of materials between
> the two methods is close, so that's not a factor.
> Longevity and SAFETY are! So, what is the collective
> Do You Yahoo!?
> Get email at your own domain with Yahoo! Mail.