Elevated guy anchors will do what you want if you have them properly
engineered, as I did. I totally agree with Steve. I had a PE design
the guying system, I did the mechanical drawings and contracted for
construction of the entire job. My Website shows what I did using a 10'
8" I-beam to
produce a 6' elevated guy anchor.
In fact, if you know my Website, it's intended to be a reference for
a truly engineered amateur radio antenna system - required reading
for anyone who is contemplating a new tower installation.
Today, I just processed some additional photos and will put them
up on the site tonight.
----- Original Message -----
To: <email@example.com>; <firstname.lastname@example.org>
Sent: Sunday, April 01, 2001 11:45 PM
Subject: Re: [TowerTalk] Guy wire anchoring question
> In a message dated 4/1/01 1:29:51 PM Pacific Daylight Time,
> > I've been doing my research with the "prime directive"
> > in mind, but, would like to know the collective's
> > opinion's/pro's/con's/concerns about guys tied to an
> > extended pipe or I beam which raises them above ground
> > level. Is it, or could it be, as efficient and SAFE as
> > what's suggested in the Rohn book?
> Of course they can be SAFE - you just have to engineer them properly.
> I-beam (eye-beam) is the material to use as it is stronger than a similar
> sized pipe.
> A proper elevated guy anchor is very robust - perhaps using 6-8"
> for a 4-5-foot elevated guy. Remember if you've got a 4-foot guy, it'll
> 4 times the bending moment on the anchor base than one 1-foot high so
> screw around.
> Since there's no manufacturer's specs on something like this, you need
> have someone run the calcs and help you design one for your application.
> engineer, or even better - a PE, is the person you're looking for.
> Cheers, Steve K7LXC
> Tower Tech