Isn't there a dc connection from the center conductor of the coax connector
to one of the terminals and not to the other?
----- Original Message -----
From: "dan hearn" <email@example.com>
To: "Bill Tippett" <firstname.lastname@example.org>; <email@example.com>
Sent: Tuesday, April 10, 2001 12:53 PM
Subject: Re: [TowerTalk] KLM Balun Phasing Marks
> Bill: I would connect the inputs in parallel and apply an input signal
> from a MFJ 259 or sig generator. You could put the two outputs on 2
> channels of a dual channel scope and observe if the 2 traces are in
> phase or out of phase. I think you could even connect the 2 outputs in
> series and create a very simple r.f. voltmeter with your VOM, a 1N34
> diode, and a shunt capacitor. The connection with the highest voltage
> would mean the outputs are in phase. I haven't thought real hard about
> it but think it would work.
> 73, Dan, N5AR
> Bill Tippett wrote:
> > I have 3 new KLM 4:1 baluns purchased with KLM-610 Monobanders
> > last fall. While doing some preventative maintenance, I noticed one of
> > connection studs broke clean at the outside of the nut against the PVC
> > (so there is no way to make another connection). I also have an old KLM
> > Balun circa 1980's which I can use as a substitute if I can determine
> > proper phasing connection. Note...both baluns are the same construction
> > a PVC tube and end caps...not the old old (skinny) baluns from the
> > Looking at the newer baluns with the label on top as you look
> > connector end, the phasing mark is on the right stud. However, on the
> > balun looking the same way (label on top viewed from the connector), the
> > phasing mark is on the left stud. Does anyone know if KLM was
> > their phasing marks over the years? Has anyone mixed new and old
> > am tempted to assume the phasing mark is correct but it bothers me that
> > in a different position relative to the label. M2 says there is no
> > to tell the correct orientation without taking the baluns apart and
> > inspecting both.
> > Which brings me to my next question! Has anyone disassembled
> > these baluns? It appears you can do so by undoing the locknut on the
> > connector and knocking the end cap off. This may be the easiest way to
> > check for proper phase of the two baluns but I would like to hear from
> > who may have done this before I start tearing both apart.
> > Better yet, does anyone have a better idea? I suppose I could
> > the antennas and check for gain when the two lower ones are selected but
> > open to any ideas.
> > 73, Bill W4ZV
> > --
> > FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> > Submissions: firstname.lastname@example.org
> > Administrative requests: towertalk-REQUEST@contesting.com
> > Problems: email@example.com
> List Sponsor: ChampionRadio.com - Trylon self-supporting towers,
> safety equipment, rigging gear, LOOS tension guages & more!
> FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> Submissions: firstname.lastname@example.org
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: email@example.com
List Sponsor: ChampionRadio.com - Trylon self-supporting towers,
safety equipment, rigging gear, LOOS tension guages & more!
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com