Several years ago I had the same problem with a bent mast and TH7 with a 2
meter antenna above it. Also keep in mind I had a "schedule 80" mast pipe in
place. After several of us had headscratched for a while, we decided to do
the following....it worked great for me, and may be a solution for you.
1) Tie a strong rope as far up and "above" the bent place as
2) Tie another rope to the area of the "bend"....just "below" the bend
and just above the bend. This is a simple "bridge" of the bent place on the
3) take a hacksaw, and SLOWLY saw and gradually weaken the "bent"
part....while simultaneously letting the ground crew pull downward on rope #
1.....as the cut weakens the mast, and tension pulls downward....the mast
will bend downward, and the antennas will be reachable as the mast folds
over. You can gain access to the antennas, and remove them this way.
4) Rope #2 is a "safety" measure that spans the bent area that you are
sawing through, in case the mast totally fails as it is being sawed and
weakened. In my case, the mast collapsed and folded over gently, but rope # 2
is a MUST in case Murphy is around.
I hope this suggestion helps you or someone else......I am sure there are
other ideas and better ones, but this worked great for me, and I would not
hesitate to do it again.
73 Bob WW4T
P.S. If you cant figure this out....email me and I will give you my LL #
List Sponsor: ChampionRadio.com - Trylon self-supporting towers,
safety equipment, rigging gear, LOOS tension guages & more!
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com