In a message dated 4/30/01 5:03:33 PM Pacific Daylight Time,
email@example.com writes: <<
I wonder if Steve ever got his question answered, about the IDEAL WIDTH
(of open wire spacing)?
Jim that is a very good question and that will be answered also. This is
the 51st e- mail today I've sent.
Typical spacings are 4-6" which gives a range of about 400-600 ohms Zo
depending on the wire diameter. The formula is Zo = 276 log S/r. S = wire
spacing and r =wire radius. Spacings beyond 6" raises the Zo very little.
As it turns out the width and Zo are not all that important as is the tuners
ability to match the Z at the end of the feedline. This is determined by the
Zo of the line and antenna Z.
Since the MB has a wide range, transfer of energy to the feedline still
occurs when adjusted properly. The longevity of the spacers is "very
important as is the length of the feedline." I sill have one open wire
feedline over 60 years old. This is what causes the "big problems" and tuner
designs that don't work well. Don't use wooden dowels boiled in wax--they
make a "RF Crackeling Sound".
I have one open wire feedline that's in the shape of a sine wave. Would you
believe it was run staight originally but had a very high SWR on it and it
changed it's shape. That's an absolutely true story--I just made it up! I
have one made up that way using 1/4" copper tubing and can get a lot of hams
to beleive it when I can keep a straight face. That also appeared in QST as
a Jeeves cartoon. k7gco
List Sponsor: ChampionRadio.com - Trylon self-supporting towers,
safety equipment, rigging gear, LOOS tension guages & more!
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com