Guy Insulator Placement de N4KG (Feb 2000)
The following lengths between insulators have
resonances between the conventional bands
(which places their resonancesin the WARC bands :-)
- 27, 40, 58, and 76 ft. (per ARRL Antenna Book)
You may want to make your wires slightly shorter
to compensate for the capacitive end loading of the
loops through the insulators.
You need to place the first insulator as close to the
tower as possible to prevent coupling to continuous
wire from one insulator, through the tower, to another
For the first insulated section, I like to use a short
piece of 10 to 12 ft between insulators. This length
is substantially less than 1/2 wavelength (WL) on
10M and will therefore be nearly invisible on all frequencies
below 28 MHz. For even better isolation, use two 10-12
ft sections before going to longer spans.
de Tom N4KG
On Fri, 04 Feb 2000 02:34:09 +0000 Peter Larsen <firstname.lastname@example.org> writes:
> Hi All:
> Could some one please send me the recommended lengths
> of guy wires to break up resonance.
> I know this has been discussed here before, but I just get lost
> in the archives.
> Finally the 100 foot guyed tower is going to go up!
> Peter J. Larsen
> VE6YC DO21wc
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
List Sponsor: Are you thinking about installing a tower this summer? Call us
for information on our fabulous Trylon Titan self-supporting towers - up to
96-feet for less than $2000! at 888-833-3104 <A
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com