Sounds like you may have BC station pickup on the tower. Try your
exciter on low power and I bet it works OK;. 73, Dan, N5AR
Pete Smith wrote:
> My education has just been found wanting again. I'm trying to set up a
> shunt feed for my tower for 160m. After tapping up the tower about 30
> feet, I set up a test rig at the feedpoint to let me clip-lead in various
> values of low-voltage ceramic caps in series with the shunt lead, to tune
> out the presumed inductive reactance. As I added capacitance to the series
> cap in the shunt feed and measured the Z, I could see it come down as I
> added more C -- in other words, it behaved as I expected. I found that
> with 440 pf in series, my Autek RF-1 says that minimum Z occurs at 47 ohms
> at 1895 khz. It is a relatively sharp minimum.
> Yet when I switch the meter to SWR, it says it is off-scale high.
> Is this possible? Doesn't minimum Z (R+j0)represent resonance? And if
> that minimum number is ~50 ohms, shouldn't the SWR be somewhere under 2:1.?
> The meter reads all right on other antennas for other frequencies, and with
> a 50-ohm resistor across the coax connector it reads close to 1:1 SWR at
> 1.8 MHz.
> There must be something here I don't understand. Any help gratefully
> 73, Pete N4ZR
> List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
> Trylon Titan towers, coax, hardline and more. Also check out our self
> supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
> FAQ on WWW: http://www.contesting.com/FAQ/towertalk
> Submissions: email@example.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: firstname.lastname@example.org
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com