In a message dated 10/22/01 12:58:04 PM Pacific Daylight Time,
I never solder the shield to the connector. I just cut the outer jacket off
and screw the connector on to the shield and solder the center conductor.
Been doing it for 30 years and have not had a problem no matter what
connectors I use.
This way they are also VERY easy to re use.
Ready to be flamed.. :-))
At 17:28 2001-10-22 , you wrote:
>When I do solder connectors to the shield, I use a big soldering
>gun and hit the connector near the holes with a grinder or file before
>I never have a problem soldering when I do that, no matter who's
>connectors I am using.
>73, Tom W8JI
I didn't have any solder one time and just screwed the coax in the connector.
I pinched the center pin on the center wire for a good connection there. I
forgot about it as it worked I thought. I had SWR changes from time to time,
RF in the shack and even connector heating with 1 KW AM before I realized
what was causing it. The shield has got to be soldered even inside the shack.
In the last Century I had an article in CQ on coax showing how I drilled out
the 4 holes with a 9/64 drill to enlarge the hole a bit and I also bevel the
hole with a larger drill. Those holes have always been too damn small. This
The use of a 250W iron I have to believe is perhaps causing a solder problem.
I use a heavy tipped 47W iron. The larger and beveled hole enables the iron
tip to get deeper in the hole for heat transfer.
Pollyfoam coax will start to foam out the holes if you don't get the solder
to flow soon enough. Some times the foam flows before the solder does. When
that happens cut it off and start over. Enlarging and beveling the holes
speeds up the solder flow. I've also wrapped the shield with a bare #30 or
smaller copper wire then carefully tinned it, and let it cool before screwing
it in the connector and then soldering through the holes. I've even
preheated the connector and tinned the holes before screwing the coax into
the connector. These techniques have worked on every connector I've used.
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com