> Have been using at NQ4I M-M 1/4 slopers fed against the tower for 15
> years with lots of success on 160m and no radials...guess the antenna
> is too dumb enough to know the difference...de Rick nq4i
I don't recall anyone saying half-slopers NEVER "work". What
everyone was pointing out is the person asking the question had a
bad situation, and why his situation was bad compared to other
He had an antenna/tower combination that was very likely resonant
on or near 160, and nothing at the top of the tower to act as a
The problem with single half-slopers is they totally depend on the
impedance at the attachment point of the tower to work. That
impedance is a function of how much "stuff" is hanging off the
tower, MUCH more than it has anything to do with grounding at the
bottom of the tower or things like feedline chokes.
Naturally there are systems that work, but from what I can see it is
mostly just by luck rather than careful planning.
I looked around for some references, but could find none. It is
unfortunate that no one has written a good article about how to
make half-slopers work.
73, Tom W8JI
This list is sponsored by the new eHam.net Store. When you buy products
like ICE filters, Array Solutions StackMatch, or M-Squared Antennas from
the eHam Store for the same price you pay direct, a portion of the sale
price goes to support this list. Check it out at http://www.eham.net.
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com