There is LOTS of stuff NOT in the Rohn books. There is a lot more stuff
MISSING than is actually there. You have found a couple of examples. I
have Rohn catalogs going back to about 1968 and I have never seen that stuff
in any of them. Another thing missing is any mention of ever using the
GAS604 screw-in anchors (or any other screw-in anchors, I believe) for any
What you do see in the Rohn books are SOME examples of how you might
properly install a Rohn tower. If you want to do anything other than what
is shown in the examples, you need to figure it out for yourself or hire a
PE. If you are Bill Gates, you can hire Rohn to do the engineering for you
. . .
Dave Hachadorian wrote:
> On Mon, 18 Feb 2002 10:51:21 -0500 firstname.lastname@example.org writes:
> > I'm planning on installing a guyed 50' Rohn 25 tower, to hold a
> > single
> > three element tribander. I've gotten the Rohn engineering drawings
> > but
> > I dont specifically see any plans for an approved base that either
> > uses the hinged plate base, or a buried section of tower as the
> > base mount.
> > I do see detail regarding freestanding/unguyed towers, but not
> > for guyed. Im specifically looking for hole size and volume
> > information.
> > Is that info available anywhere, for a guyed 50' 25 tower?
> Interestingly, I don't see any info in my 1996 catalog for the
> hinged base or the buried section of tower for use in guyed
> The drawings for guyed towers all show the pier pin mounting
> arrangement, and The CB1 base is specified, which is
> 2' x 2' x 4' deep, with specified vertical and horizontal
> rebar. The drawing # is C610621. Guy anchor details are
> on Dwg. C620643.
> Dave Hachadorian, K6LL
Where do you get ICE bandpass filters & beverage matching boxes? The
same place that pays for the hosting of this list: The eHam Store.
Order online at http://store.eham.net.
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Administrative requests: towertalk-REQUEST@contesting.com